member
Posts count: 5
13 years, 5 months ago
nuSPIC / Feedback of beta status / Post
- put somewhere a disclaimer "register to play!"
- more functions for the histogram please (number of bins)
- when one applies one change , please highlight all changes done (maybe in different colors) and not only the last one
 
member
Posts count: 6
13 years, 5 months ago
nuSPIC / Feedback of beta status / Post
The DC generator doesn't seem to have any effect on neurons. Maybe I used it in a wrong way...
 
member
Posts count: 9
13 years, 5 months ago
nuSPIC / Feedback of beta status / Post
I only just found out that the mean firing rate for the Poisson generator is also available to be set (couldn't previously see it, so assumed that it was set with a sensible default value). Instead, this was set to have a default of 0 (facepalm) ...

As this is a pretty basic parameter for a poisson generator, I would suggest showing it along with delay and weight.
 
member
Posts count: 6
13 years, 5 months ago
nuSPIC / Feedback of beta status / Post
Would it be possible, to encode the strength of the connections in terms of the thickness of the connector in order to support the interpretation of the connectivity matrix? An alternative could be to pop up a little window when pointing to a link, or pointing to a neuron, with all the relevant information about parameters.
 
member
Posts count: 9
13 years, 5 months ago
nuSPIC / Feedback of beta status / Post
Although we have the connectivity matrix, it's difficult to view this on the network figure as many connections terminate/begin at the same place. Would it be possible to designate one side as input, and the other output, so at least the user can determine which neuron is pre/post for a connection?
 
member
Posts count: 6
13 years, 5 months ago
nuSPIC / Feedback of beta status / Post
Recording membrane potentials from several neurons yields an array of membrane potential traces. It is not immediately clear, which corresponds from which neuron, though. A small label should fix this. It would be more convenient to turn on magnification by a mouseover/click event.
 
member
Posts count: 9
13 years, 5 months ago
nuSPIC / Feedback of beta status / Post

My suggestion would be to include a spike detector (and perhaps voltmeter), at least for the first network, with minimal connectivity if you're concerned. I suggest this, only because everybody for the first time presses 'Simulate' then goes 'uh, and now what?'.

Think of it as a type of spic-tutorial ;)
 
moderator
Posts count: 2
13 years, 5 months ago
nuSPIC / Feedback of beta status / Post
After testing beta-status of nuSPIC web-application, you can post your suggestion, ideas, tips, comments, advicing, ... etc. in this topic.
This forum is also in beta-status.


Thank you for you time,
nuSPIC Team

Beer and chips are free.